0

Aspire K3 kit

Was £29.99 Now £22.99

Earn23 reward points

Quantity

Choose Strength

The Aspire K3 is slightly wider and heavier than the K2 - the increased diameter allows it to hold more e liquid and have a higher battery capacity (1200 mAh)

The kit includes the K3 battery, 2 ml capacity K3 tank, two replaceable Aspire Nautilus BVC coils (one of which is pre-installed in the tank ready to use), charging lead and user guide.

The K3 has a rechargeable battery operated easily by using a single button. The casing is made from durable and lightweight carbon fibre. The battery has a 1200 mAh capacity, which is a measure of how much energy it can store at one time and can last around a day before recharging in normal use

The tank simply screws into the top of the battery and holds up to 2 ml of e liquid, the maximum allowed under UK & EU law

The K2 is smaller and lighter than other products in the series. It measures around 14 cm long and 1.8 cm in diameter full assembled.

Aspire K3 quick start kit contents

  • Rechargeable carbon fibre battery (1200 mAh capacity)
  • 2 ml capacity K3 tank
  • 2x 1.6 ohm resistance Aspire Nautilus BVC coils (one pre-installed)
  • Micro USB charging cable
  • User guide

Aspire K3 user guide

The kit is extremely easy to operate. All you need to do is fill with e liquid, recharge the battery and change the coil when needed

  • Filling with e liquid - Turn the tank upside down and unscrew the base. Holding the tank at 45 degrees pour the liquid along the inside wall, avoiding the central air tube. Then replace the base section. When you first use your tank or change the coil wait five minutes after filling to allow the e liquid to absorb fully into the coil (called ‘priming the coil’) to prevent damage and unpleasant ‘dry hits’
  • Turning on and off - Press the fire button five times at the start and end of your vaping session to turn the device on or off. The fire button will flash three times
  • How to vape - Just place the mouthpiece between your lips and slowly draw in breath whilst pressing the button for up to 15 seconds
  • When to refill - Always refill your tank with e liquid before it is completely empty to avoid damaging the coil
  • When to recharge - When you press the button the light will glow blue which changes to orange if starting to run low. When it is too low the light will flash orange 15 times and the device will switch off
  • Charging - Use the cable to connect the base of the battery to a USB port or mains adaptor. The light initially flashes 3 times, then gradually changes from orange to blue. When full charged it will flash 20 times
  • When to change the coil - You should change the coil when you first see a reduction in vapour. If you don’t you will start to experience less flavour and a burnt taste – change the coil immediately
  • Changing the coil - With the tank upside down remove the base as before. Coils simply screw into the base. Remember to prime the coil again after refilling (allowing 5 minutes after changing the coil before use)

Aspire K3 features

  • Simple to use - operated by a single button
  • Easy to charge - just connect to a USB port from a laptop, PC or UK mains USB adaptor (sold separately)
  • Lightweight and durable - carbon fibre shell
  • Vape all day - 1200 mAh capacity lasts around one day in normal use before recharging
  • Spare coil - includes 2 coils (each lasts 3-4 weeks in normal use) to get you started
  • Safety first - features short circuit, low voltage, overcharge & high temperature protection and will automatically cut off if activated for 15 seconds

Aspire K3 technical specifications

Aspire K3 battery

  • Dimensions: 84 mm x 18 mm diameter
  • Capacity: 1200 mAh
  • Connection: Standard 510 with four airflow inlets
  • Charging: Micro USB port

Aspire K3 tank

  • Dimensions: 59 mm (including screw thread) x 18 mm diameter
  • Capacity: 2 ml
  • Connection: 510 screw thread

Aspire Nautilus BVC coils

  • Coil material: kanthal
  • Wick: organic cotton
  • Resistance: 1.6 ohm

Charging cable

  • Micro USB